Err 2 — Victron
Battery voltage too high
severity: degradedconfidence: verifiedkind: error1 citation(s)
Scope: Victron SmartSolar / BlueSolar MPPT charge controllers, Inverter RS / Multi RS, Orion Smart DC-DC
Meaning
The charger has stopped because the battery voltage is above the configured limit. The error auto-resets once the voltage drops.
Likely causes
- Other charging equipment on the same battery raising the voltage
- A fault in the charge controller
- Battery system voltage (12/24/48 V) set lower than the actual battery
Checks
- Check for other chargers or alternators on the same battery
- Verify the battery voltage setting matches the connected battery in VictronConnect
Safety flags
- lithium_battery
Requires a qualified installer. Isolate and escalate to a qualified installer/electrician.
Parts
- charge controller
- battery
Citations
https://www.victronenergy.com/live/mppt-error-codes
type: vendor_kb · retrieved: 2026-11-21 · locator: § Err 2 - Battery voltage too high
This error will auto-reset after the battery voltage has dropped.
Independent and unofficial. Verify against the manual for your exact model and serial number before acting. See this code on the owning surface: SolarDesk.