2x1C — SolarEdge
RCD sensor error
severity: stopconfidence: verifiedkind: error1 citation(s)
Scope: SolarEdge single-phase and three-phase inverters (Europe & APAC)
Meaning
The inverter's residual-current (RCD) sensor reported an error, so the ground-fault protection path cannot be trusted. The addendum prints the message with no field remedy; SolarEdge support handles it.
Likely causes
- RCD sensor or its measurement circuit failed
- Sensor harness fault on the control board
Checks
- Note the code and serial number
- Contact SolarEdge support; do not bypass or disable RCD protection
Safety flags
- pv_dc
Requires a qualified installer. Isolate and escalate to a qualified installer/electrician.
Parts
- RCD sensor
Citations
type: manual · retrieved: 2026-11-21 · locator: p. 3
RCD Sensor Error
Independent and unofficial. Verify against the manual for your exact model and serial number before acting. See this code on the owning surface: SolarDesk.