D25 — Barudan

Stopped for Thread Break

severity: stopconfidence: verifiedkind: status1 citation(s)

Scope: Barudan XS/XY series

Meaning

The machine stopped because the thread-break detector saw a break. The source says to fix the thread and continue; a false break points to thread wrapped around the detect wheel or a low T-Break parameter

Fix steps

  1. Message that machine stopped due to thread break
  2. Fix thread break and continue
  3. If thread is not broke (false thread break) check that thread is wrapped around the thread detect wheel on the tension assembly
  4. If false thread breaks occur on small stitches try increasing MC parameter #19, T-Break to a higher value

Citations

https://www.barudanamerica.com/wp-content/uploads/2018/11/XS-XY_Error_Messages.pdf

type: manual · retrieved: 2026-11-21 · locator: p. 7

D25 Stopped for Thread Break
Independent and unofficial. Verify against the manual for your exact model and serial number before acting. See this code on the owning surface: FaultDesk.